Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: [802SEC] 802 O&A balloting proposal



Folks-

The Lord giveth and the Lord taketh away.

My interpretation of the chair's right to grant voting membership to a WG presumes the right to undo what he has done.
Since that explicit right is neither granted nor forbidden, I believe it is a matter of interpretation.
That would make it a matter for a ruling by the chair (WG or EC?).
Since those added by the chair presumably do not have a sufficient attendance record, I would argue that they could be deleted at the next general purge for lack of attendance.

Solutions:
- A ruling by the chair (lacking evidence to the contrary) that those added by the chair can be deleted by the same standards of and subject to an ordinary regular purge.
- A ruling by the EC Chair that addition for only a specific ballot group is permissible.
- Other?

Geoff

On Tuesday, October 4, 2022, 01:25:55 PM PDT, Glenn Parsons <00000f6f9e80d40c-dmarc-request@listserv.ieee.org> wrote:


James,

One concern with the proposal is that the group of voters added to the 802.1 WG so that they would be in the P802REVc pool, will be voters until they age out.  

No. The WG Balloting Group is set for all time at the start of Initial WG Ballot. If a person gains or loses 802.1 voting rights after that start, it has no effect on the membership of the project ballot group. [In the same way that for "Sponsor Ballot" death is just a change of address.]


You confirmed that the WG chair can add voters but not remove them.  During this time they will also become voters in other WG ballots that are started.  And will result in quorum issues (if the group is large).

Is there anyway to mitigate this without a rule change?

Cheers,
Glenn.

-----Original Message-----
From: ***** IEEE 802 Executive Committee List ***** <STDS-802-SEC@listserv.ieee.org> On Behalf Of James P. K. Gilb
Sent: Tuesday, October 4, 2022 4:05 PM
To: STDS-802-SEC@LISTSERV.IEEE.ORG
Subject: Re: [802SEC] 802 O&A balloting proposal

All

Based on the rules I have found, it is theoretically possible for IEEE
802.1 to form a subgroup as a comment resolution group and "allow participation of persons who are not Working Group Members and specify the terms and conditions under which they participate in the subgroup."

Note that the 802.1 WG could delegate responsibility for resolution to the subgroup.  ("Any resolution of a subgroup shall be subject to confirmation by the Working Group, unless previously or otherwise delegated to the subgroup.").

IMHO.

James Gilb

IEEE-SA Standards Board OM

5.4.3 Conduct of the standards balloting process

...

The Standards Committee shall ensure that comment resolution occurs via a comment resolution group, which is a subgroup of the working group.

...

JPKG NOTE: The preceding is for SA ballot.

IEEE 802 LMSC WG P&P

5. Subgroups of the Working Group

The Working Group may form subgroups for the conduct of its business.
Membership in the subgroup is granted to any Member of the Working Group. Such formation shall be explicitly noted in the meeting minutes.
At the time of formation, the Working Group shall determine the scope and duties delegated to the subgroup, may decide to allow participation of persons who are not Working Group Members and specify the terms and conditions under which they participate in the subgroup. Such formation shall be explicitly noted in the meeting minutes. Any changes to the scope and duties of the subgroup will require the approval of the Working Group. Any resolution of a subgroup shall be subject to confirmation by the Working Group, unless previously or otherwise delegated to the subgroup.

The Chair of the Working Group shall appoint, and may dismiss, the Chair of the subgroup.

On 10/4/22 12:14, Geoff Thompson wrote:
> As to be discussedSee attached
>
>
> ----------
> This email is sent from the 802 Executive Committee email reflector.  This list is maintained by Listserv.
>

----------
This email is sent from the 802 Executive Committee email reflector.  This list is maintained by Listserv.

----------
This email is sent from the 802 Executive Committee email reflector.  This list is maintained by Listserv.

To unsubscribe from the STDS-802-SEC list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-SEC&A=1