| Thread Links | Date Links | ||||
|---|---|---|---|---|---|
| Thread Prev | Thread Next | Thread Index | Date Prev | Date Next | Date Index |
|
Hi, Liwen Thank you for your reply. CID4443 mentioned scheduled STA and responding STA. I agree that the responding STA (or scheduling AP) should not transition to LC Mode, even if the peer STA (the scheduled STA
or requesting STA) terminates the TWT SP early. However,
for a scheduled STA that has enabled DPS mode and indicates that there are no pending traffic by transmitting a QoS frame with EOTSP set to 1, the STA shall transition to LC Mode. Best Regards, Yajun 发件人: Liwen Chu <liwen.chu@xxxxxxx>
[外部邮件]
此邮件来源于小米公司外部,请谨慎处理。若对邮件安全性存疑,请将邮件转发给misec@xxxxxxxxxx进行反馈 Hi Yajun, Thanks for the discussion. EOTSP equal to 1 is used at the requesting STA or TWT scheduled STA side to indicate no pending frames. It doesn’t mean that the peer TWT STA, e.g. the TWT scheduling STA (AP of the broadcast
TWT schedule), has no pending frames. Best Regards, Liwen From:
程亚军 <chengyajun@xxxxxxxxxx>
Hi, Liwen As I mentioned during the joint meeting, a non-AP STA utilizes the TWT early termination procedure to indicate that it had
no pending traffic to transmit during the ongoing TWT SP, rather than indicating that no frames were detected.
I might not agree with your decision to reject this comment. Because this condition was not included in the EMLSR rule of
switching back to listening mode. A DPS non-AP STA (acting as a scheduled STA) shall transition to LC Mode immediately after transmitting a QoS Null frame
with the EOTSP subfield set to 1 during an ongoing TWT SP. This improves power-saving performance for the non-AP STA. On the contrary, if a DPS non-AP STA remains in HC mode after terminating a TWT SP early, maintaining the HC mode until the end of the TWT
SP results in unnecessary power consumption. The resolution of this CID should be revised to include an additional condition for a DPS non-AP STA to transition back
to LC Mode. Specifically, in addition to following the EMLSR rule of switching back to listening mode, a DPS non-AP STA shall transition
to LC Mode immediately upon transmitting a QoS Null frame with the EOTSP subfield set to 1 during an ongoing TWT SP. BRs, Yajun 发件人: Liwen Chu <liwen.chu@xxxxxxx>
[外部邮件]
此邮件来源于小米公司外部,请谨慎处理。若对邮件安全性存疑,请将邮件转发给misec@xxxxxxxxxx进行反馈 Hi Alfred and all, I uploaded 11-25/1895R1 updated per the feedbacks. Best Regards, Liwen From: Liwen Chu <liwen.chu@xxxxxxx>
Hi Alfred, Thanks. I had R1 based on the feedbacks I received.
I will incorporate your suggestions to R1 and upload it today. Best Regards, Liwen From: Alfred Asterjadhi <asterjadhi@xxxxxxxxx>
Hi Liwen, all, Please find some green tags for the CIDs in the attached file (also some suggestions/comments). Regards, Alfred --
Alfred Asterjadhi, PhD IEEE802.11 TGbe/TGbn Chair, Qualcomm Technologies Inc. Cell #: +1 858 263 9445 Office #: +1 858 658 5302 To unsubscribe from the STDS-802-11-TGBN list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBN&A=1
To unsubscribe from the STDS-802-11-TGBN list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBN&A=1
To unsubscribe from the STDS-802-11-TGBN list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBN&A=1
To unsubscribe from the STDS-802-11-TGBN list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBN&A=1 |