Dear 802.16 Folks,
Both the P802.16Rev3 and P802.16.1 drafts are in IEEE Sponsor Ballot Recirc, with a deadline of 2012-03-06, 11:59pm ET. See the cover letters (802.16 Mentor Docs 0143 and 0144) and comment databases (802.16 Mentor Docs 0117 and 0118) for details.
If you are a member of the Sponsor Ballot Group, you should have been notified on how to participate using IEEE-SA's myBallot system. If you are not a member of the Sponsor Ballot Group, you are not entitled to vote. However, comments that you submit directly to the WG will be considered. These should be prepared in Commentary, as follows:
Sponsor Ballot Group members may also submit comments in Commentary according to this procedure. However, please be aware that no comments submitted directly to the WG will be considered as part of a Disapprove vote. For any comment to be considered as a valid element of a Disapprove vote, the comment must be entered into the myBallot database by the voter. Please do not submit the same comment using both processes, as this would result in needless complication. After the ballot closes, we'll transfer all comments into a single Commentary database for comment resolution. It may be possible for arrange a brief period for reply comments. If necessary, your comments may refer to an uploaded contribution document. Contributions must follow the new IEEE 802.16 Document Submission Instructions < http://ieee802.org/16/submit.html>. In order to ensure that all parties to the Sponsor Ballot are explicitly aware of your contribution and where to find it, it is essential that you refer to it properly, by document number, in your comment. Upload your contribution using the IEEE 802.16 Mentor documentation system < http://doc.wirelessman.org>., using the following file codes:
*For P802.16Rev3, use Code Code 00R3. *For P802.16.1, use Code Code 01R0.
Regards,
Roger |