Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: [10GMMF] Task 2 and 4 slides for meeting Dec15th - OM3 fibre measurements




Jonathan,
presuming that MMCL is the native launch from the TOSA directly into MMF, then the increase in PIE-D relative to the SMCL case would be attributable to power that gets filtered out by the SM cord.   Into which mode groups this filtered power couples is of key importance, since the modal delay difference relative to the lowest order modes will increase with mode group number, leading to higher PIE-D.   So it becomes critical to quantify the native launch.  While a CPR measurement  can be of some assistance, it can only tell us how much power lies in higher modes, not which higher modes are excited.  So its utility is very limited, unless the CPR requirement is set very low, meaning very little power is permitted to be filtered out by a SM cord.  But an encircled flux measurement could provide sufficient information.  Can you measure EF at 1300 nm?

In addition, the native launch would need to be examined with the effects of offset connections near the transmitter.  With this effect included, it is likely that the performance of this particular native launch will degrade to levels similar to those of the MCP without offset connectors (green bars on slide 5).

Regards,
Paul Kolesar
SYSTIMAX® SOLUTIONS
1300 East Lookout Drive
Richardson, TX 75082
Phone:  972.792.3155
Fax:      972.792.3111
eMail:   pkolesar@systimax.com



Lew Aronson <lew.aronson@FINISAR.COM>
Sent by: owner-stds-802-3-10gmmf@IEEE.ORG

12/14/2004 05:08 PM
Please respond to
"IEEE P802.3aq 10GBASE-LRM" <stds-802-3-10gmmf@IEEE.ORG>

To
STDS-802-3-10GMMF@listserv.ieee.org
cc
Subject
Re: [10GMMF] Task 2 and 4 slides for   meeting Dec15th - OM3 fibre measurements






Jonathan,

What is multimode center launch exactly (MMCL)?  Also, why do you have a 2nd 7 um offset connector in the 50 MCP case?
It is shown after the main spool so I presume it does not have a large effect, but what was the motivation?

Finally, did you ever test any of the OM3 with a 62-MCP (i.e larger offset than 16 um).

Lew

Lew Aronson  (lew.aronson@finisar.com)
Finisar Corporation
1308 Moffett Park Drive
Sunnyvale, CA  94089-1133
408-542-4215 (PH)
408-543-0083 (FAX)


-----Original Message-----
From: Jonathan King [mailto:jking@BIGBEARNETWORKS.COM]
Sent: Tuesday, December 14, 2004 2:22 PM
To: STDS-802-3-10GMMF@listserv.ieee.org
Subject: Re: [10GMMF] Task 2 and 4 slides for meeting Dec15th - OM3
fibre measurements


Here are some measurements of OM3 fibre PIE-D values for various launch
conditions, contribution for task 2 and 4 meeting on wednesday 15th Dec
04
best wishes

Jonathan

tel: 1 408 524 5110
e-mail: jking@bigbearnetworks.com
fax: 1 408 739 0568

Jonathan King
Director, Optical Systems
BigBear Networks
345 Potrero Avenue
Sunnyvale, CA 94085