FW: cls51 PCS output timing
Justin,
On the PCS output it's not the 600ps board spec that's tight. It's the
1100ps PCS output spec.
As you point out, we want more setup/hold time for the PCS in the other
direction. Similarly we need to allow more slack to the PCS in the transmit
direction.
I would like to get numbers from some board/connector people. I don't think
they need 500ps-600ps.
Henning
-----Original Message-----
From: Jscquake@xxxxxxx [mailto:Jscquake@xxxxxxx]
Sent: 7. december 2000 03:10
To: henning.lysdal@xxxxxxxxx; stuart_robinson@xxxxxxxxxxxxxxxx
Cc: steen.christensen@xxxxxxxxx
Subject: Re: cls51 PCS output timing
Hello Henning, Stuart,
If the 600ps is tight then the return path PMA to PCS is even tighter. That
is spec'd with a 500ps margin ...
PMA output 1500-400=1100ps
PCS setup 600ps
----
total left for margin is 500ps
The point of the asymmetry was to give more setup and hold for the CMOS
PCS IC. I agree that we should hear from the system designers on this one.
The place where we could cut back are
1) setup and hold for the PMA input (better technologies) ... change to
+/-200ps
2) setup and hold for PCS (overly generous w/ 300ps?) ... change to 200ps
as well ... this would make everything symmetric
Total budget in both directions would be 1550-800=750ps for the board
designer (connector and traces). Thoughts?
I think I would put this out on the reflector?
Justin
In a message dated 12/1/00 3:09:10 AM Pacific Standard Time,
henning.lysdal@xxxxxxxxx writes:
> Our CMOS designers have informed me that the PCS output timing is pretty
> strict.
>
> Looking at the numbers:
> Period approx. 1.5ns (LAN mode)
> PCS output data valid: 1100ps (1500ps - Tcq_min-Tcq-max, from table 51-3)
> PMA input valid requirement: 500ps (tsetup+thold, from table 51-4)
>
> Margin for board and connectors: 600ps
>
> I think we should get a realistic estimate from a system implementer on
the
> required margin for the board before we finalize these numbers. If not,
we
> end up putting tough restrictions on the PCS design for no appearant
reason.
>
Justin Chang
Quake Technologies, Inc.
50 Airport Parkway, San Jose, CA. 95110
Tel: 408-437-7723 email: justin@xxxxxxxxxxxxx
Fax: 408-437-4923 internet: www.quaketech.com