RE: comments on Clause 47
Mike,
Some comments on your first point.
The 2.3V upper limit was reached by compromise in November at Tampa.
Approval was overwhelming, but not unanimous. Several parties other than
yourself have verbally suggested the same increase that you are suggesting,
though none have submitted comments. The motivation behind the limit was
mainly to put some reasonable limit on the DC voltage that the AC coupling
must withstand. Some parties were concerned that a 3.3V limit might rule out
certain AC coupling approaches. The main proponents of a lower number have
since agreed that 3.3V would probably be acceptable. However, there may be
some parties who are designing receivers capable of tolerating the 2.3V
limit without requiring coupling capacitors; these parties might object to
raising the number to 3.3V. If the goal is to allow 3.3V operation, why not
propose 3.3V + 5% for power supply variation? One comment has been submitted
proposing 3.4V. On the low side, I am not aware of any objections to
reducing the lower limit below -0.3V. But again why not allow margin for
termination impedance variations and other factors that could increase the
swing slightly?
-Dawson
-----Original Message-----
From: Mike Jenkins [mailto:jenkins@xxxxxxxx]
Sent: Thursday, December 28, 2000 1:45 PM
To: Reflector, Higher Speed Study Group
Subject: comments on Clause 47
All,
I have two comments on the XAUI driver electrical specs in clause 47.
Ballot comments will be submitted, but I want to air them here on the
reflector in case I'm missing some piece of history on these issues.
1) Section 47.3.3 Driver characteristics: (Table 47-1)
Present maximum driver voltage is 2.3 volts. I'm unaware
of the origin of this number, but it seems to pointlessly(?)
exclude devices with higher supply voltages. I propose
this spec be changed to 3.3 volts.
Also the minimum driver voltage is listed as -0.3 volts.
I propose that this value be changed to -0.4 volts. The
motivation is to not preclude any driver that swings
around ground. The max dif'l swing of 1600 mVp-p implies
a max single-ended zero-peak voltage of 400 mV, which
would be the max swing below ground.
2) Section 47.3.3.5 Driver template: (Table 47-3)
Present values for X1 and X2 are 0.325 and 0.450 UI,
respectively. I understand these are typos and comments
have likely been submitted. I propose (as I assume other
comments will) that X1 be 0.175 UI, half the peak-peak TX
jitter spec. Several values have been proposed for X2,
including X1+0.19 UI (the Fibre Channel value), as well as
a larger value. I propose X2 = X1+0.205 UI = 0.380 UI.
The derivation for this is attached, and is the closest
I can come to the original Fibre Channel methodology.
(The difference between X2=X1+0.19 and X2=X1+0.205 is
about 5 ps, so this is not much of a big deal either way.)
Thanks in advance to anyone who can provide (helpful) feedback.
Regards,
Mike
--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Mike Jenkins Phone: 408.433.7901 _____
LSI Logic Corp, ms/G715 Fax: 408.433.7461 LSI|LOGIC| (R)
1525 McCarthy Blvd. mailto:Jenkins@xxxxxxxx | |
Milpitas, CA 95035 http://www.lsilogic.com |_____|
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~