Re: Clause 48: Errors after T.
Justin,
Check_end performs this function. D2.3 add a call to the check_end
function in state DATA_MODE_START of the PCS Receive state diagram.
Best Regards,
Rich
--
Justin Gaither wrote:
>
> Everyone,
> During the Plenary, it was determined that we need to push an error that
> occurs after the /T/ back 1 column so that it is included inside the /S/
> and /T/ delimeters. My question is, can we just push all errors back on
> column, or must we determine if it is in the column following a //T//?
>
> I could not find this in D2.3, where did it get put?
>
> Thanks
>
> --
> Justin Gaither Phone: 512-306-7292 x529
> RocketChips a Division of Xilinx Fax: 512-306-7293
> 500 N. Capital of TX Hwy.
> Bldg 3 email: jgaither@xxxxxxxxxxxxxxx
> Austin, TX 78746 WWW: www.rocketchips.com
---------------------------------------------------------
Richard Taborek Sr. XAUI Sherpa Intel Corporation
Santa Clara Design Center Network Components Division
408-496-3423 Fax: 408-486-9859 Cell: 408-832-3957
3101 Jay Street, Suite 110 Santa Clara, CA 95054
mailto:rich.taborek@xxxxxxxxx http://www.intel.com