Re: MDIO addressing
Stefan,
You access the DTE-XS registers (including any of its
'PCS' control registers) by sending MDIO frames with a
DEVAD = 5 onto the MDIO bus, similarly the PHY-XS is
accessed by sending frames with a DEVAD = 4 and the
10GBASE-R PCS or 10GBASE-X PCS is accessed by sending
frames with a DEVAD = 3. This allows individual and
separate configuration of each of the devices.
The PCS device (3) in table 45-1 refers to the PCS
device within the PHY area of figure 46-1 (the box
just above PMA). It comprises the 10GBASE-R PCS or the
10GBASE-X PCS - depending on your port type.
Regards
Ed
--- "Stefan M. Wurster" <stefan@xxxxxxxx> wrote: >
> When using a configuration as in figure 46-1, how
> does one address the
> individual PCSs (the PCS of the DTE-XS, the PCS of
> the PHY-XS and the PCS of
> the "PHY" device going to the optics).
>
> Given that each PCS could be configured in a
> different fashion in each
> device, how is this handled within the Management
> Interface?
>
> Also, what does the PCS device #3 in Table 45-1
> refer to?
> Which of the PCSs (referring to figure 46-1) does it
> comprise?
>
> Stefan Wurster
> Dir. Engineering
> TDK Semiconductor
>
____________________________________________________________
Do You Yahoo!?
Get your free @yahoo.co.uk address at http://mail.yahoo.co.uk
or your free @yahoo.ie address at http://mail.yahoo.ie