Hi Chad,
________________________________________
From: Chad Jones (cmjones) <cmjones@xxxxxxxxx>
Sent: Friday, October 21, 2016 17:26
To: STDS-802-3-4PPOE@xxxxxxxxxxxxxxxxx
Subject: [802.3_4PPOE] cmjones TDL
All, please find the resolution for my TDL attached. Recall that my AI was to find a resolution to the statement ‘decimal value of bits’ in 30 and 79. If you care about these sections, I would expect you to look at the attached and give feedback if you have any. It should only take 5 minutes of your time (unless you disagree and have to send me feedback…). I will be submitting this document as a remedy to one of my comments against D2.1.
Chad Jones
Tech Lead, Cisco Systems
Chair, IEEE P802.3bt 4PPoE Task Force
Looks good, this gets rid of an awkward construct.
I would further suggest:
To get rid of the word "encoded" wherever it is used.
eg: The PD measured voltage value is according to Table 79-7f, where X is aLldpXDot3....
Kind regards,
Lennart
________________________________________
From: Chad Jones (cmjones) <cmjones@xxxxxxxxx>
Sent: Friday, October 21, 2016 17:26
To: STDS-802-3-4PPOE@xxxxxxxxxxxxxxxxx
Subject: [802.3_4PPOE] cmjones TDL
All, please find the resolution for my TDL attached. Recall that my AI was to find a resolution to the statement ‘decimal value of bits’ in 30 and 79. If you care about these sections, I would expect you to look at the attached and give feedback if you have any. It should only take 5 minutes of your time (unless you disagree and have to send me feedback…). I will be submitting this document as a remedy to one of my comments against D2.1.
Chad Jones
Tech Lead, Cisco Systems
Chair, IEEE P802.3bt 4PPoE Task Force