| Thread Links | Date Links | ||||
|---|---|---|---|---|---|
| Thread Prev | Thread Next | Thread Index | Date Prev | Date Next | Date Index |
|
George, Sounds perfect, thanks for going out of your way for this. My only comment is on PICS (it should be mentioned either in the pdf or in the DB as “accept zimmerman_3cg_01_1118.pdf and adjust/remove PICS/147.12 as necessary”), as we discussed
shortly. Yours sincerely Gergely From: George Zimmerman [mailto:george@xxxxxxxxxxxxxxxxxxxx]
Attached is the proposed resolution to comments from Lennart involving “shall be tested” – we plan to resolve this tomorrow (Tuesday) morning. General approach – change these to the formula “When texted using the test fixture shown in Figure xxx-yyy and the transmitter in test mode z, the transmitter …” See proposed resolutions to comments 301, 302, 308, 309, 310 attached, and example below using comment 301: Cl
146
SC 146.5.4.1
P
140 L
48
# 301 Comment Type
TR "Transmitter output voltage shall be tested using test mode 1 in combination with the test fixture shown in Figure 146-17." We can't put requirements on the tester, only on the device. SuggestedRemedy Rewrite the requirement: "When tested with the test fixture shown in Figure 146-17 in test mode 1, the transmitter output voltage shall ... <show some property>." Possibly the very next sentence already covers this. In that case, make the quoted sentence informative. PROPOSED ACCEPT IN PRINCIPLE. Change “Transmitter output voltage shall be tested using test mode 1 in combination with the test fixture shown in Figure 146-17. The transmitter output voltage shall be 2.4 V ± 5% peak-to-peak (for the 2.4 Vpp operating mode) and 1.0 V ± 5% peak-to-peak (for the 1.0 Vpp operating mode). " To: “"When tested with the test fixture shown in Figure 146-17 and the transmitter in test mode 1, the transmitter output voltage shall be 2.4 V ± 5% peak-to-peak (for the 2.4 Vpp operating mode) and 1.0 V ± 5% peak-to-peak (for the 1.0 Vpp operating mode).” George A. Zimmerman, Ph.D. President & Principal Consultant CME Consulting, Inc. Experts in PHYsical Layer Communications 1-310-920-3860 To unsubscribe from the STDS-802-3-10SPE list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-3-10SPE&A=1 To unsubscribe from the STDS-802-3-10SPE list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-3-10SPE&A=1 |