| Thread Links | Date Links | ||||
|---|---|---|---|---|---|
| Thread Prev | Thread Next | Thread Index | Date Prev | Date Next | Date Index |
|
Hi All, Hi Piergiorgio, I have a question regarding 147.3.5 (Collision detection). Earlier versions of the draft gave an implementation guideline or hint towards comparing the RX symbols with the TX symbols to detect a collision. The newer draft
D2p2 states that the method is implementation dependent. Is there evidence that there is at least one known method which can reliably detect collisions in all topology scenarios? And if not, is this a problem? The electrical characteristics of older 10Mbps 802.3 standards (I think 10BASE2 and 5) drive current into the wire, hence during collisions the DC voltage component of the signal during frame transmission can be used
to detect a collision reliably. Now with 10BASE-T1S this seems to be different. Multiple drivers will cause impedance mismatch plus a superposition of their signals. But as far as I understand the concept, apart from this there is no intrinsic mechanism
to reliably detect multiple drivers. Given that the only incarnation of a collision are random bit errors on the RX wire when compared to what it transmitted on TX, what is the likelihood of not detecting those? Especially during reasonably short symbol groups
such as BEACON or COMMIT. The draft says that COL shall be asserted within 256 bit times, this would imply collisions of PLCA control commands would not be detectable. Is this intended? In 147.3.5 b) it is stated that a third PHY shall assert CRS in case two or more stations cause a collision. Does the CRS need to be asserted during the entire time that the drivers are driving or is the CRS allowed
to glitch? What is the maximum allowed delay from reaching differential zero on the MDI until CRS is deasserted at the MII? What is the minimum required time from driving the differential pair to +-1 until CRS shall be asserted?
Assuming a worst-case attenuation through the wire, there is probably a chance that a transceiver is not even ‘seeing’ the far end driver because it overdrives its. Perhaps there is simulation data available which I am
not aware of. Regards Philip To unsubscribe from the STDS-802-3-10SPE list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-3-10SPE&A=1 |