Re: [EFM] EFM Requirements
Dear Sherman,
thank you very much for this significant and really helpful input. A couple
of questions for clarification anyway.
1. By your experience only two MPEG-2 channels are required. Why, however, US
telcos were pushing so strong for 22Mb/s downstream for VDSL motivating that by
a need in 3 video channels. Is there some specifics in video service over
Ethernet you keep in mind?
2. You mentioned loop length of 10-12 km. It seems to me that the technology
will allow 1-1.5 km. Does it still make sense to work on EFM?
3. You mentioned compatibility with HPNA. Here several questions come to the
mind.
A. Is it right that you assume EFM running over the home wiring?
B. If yes, do you mean HPNA running over the same wire with EFM or over
different wires?
C. What kind of HPNA do you keep in mind (there is no standard on HPNA)?
Thankfully,
Vladimir Oksman, Broadcom Corporation.
Sherman Ackley wrote:
> Service Provider Requirements for Ethernet in the First (two) Mile(s):
> Sherman L. Ackley, CTO
>
> The National Rural Telecommunications Cooperative provides services to over
> 350 member independent telephone companies who serve over 6 million access
> lines. Ethernet in the first mile is the most promising technology for the
> delivery of integrated voice, video and data services in the suburban and
> rural areas served by our Members. As the Chief Technology Officer for
> NRTC, I would like to submit some practical requirements as seen by the
> service providers most likely to implement this technology in the USA. The
> intent of this contribution is to help the study group prepare the
> requirements document based on actual needs.
>
> The user locations will be 90 percent residential and 10 percent business.
> Of those businesses, 90 percent will have 10 or fewer PCs.
>
> The system must work over standard high capacitance telephone outside plant
> cable. Binder group integrity is not assured. The technology should not
> force removal of bridge taps and end sections. It needs to operate without
> degradation at binder group fills over 70%.
>
> System reach is the most important aspect of the design. Ethernet in the
> first mile must operate over the longest reach possible. The number of
> households and small businesses served by a node is proportional to the
> square of the reach. For example, a reach of 3 km can serve about 100
> single-family homes per node. Doubling the reach to 6 km increases the homes
> served per node to 400. And with a 12 km reach, 1600 homes per node can be
> served. This assumes 100 percent subscribe. At 25 percent subscription,
> short reach technology gets down to some dismal financial outlooks in terms
> of cost per revenue producing subscriber as well forcing the construction of
> too many street corner server nodes.
>
> Coexistence with HomePNA on the same cable pair is essential. This feature
> will be necessary in over 75% of households served with Integrated Broadband
> services. For example, a data stream of 10 Mbps will support two MPEG-2
> high-resolution standard TV signals. The DSL will carry this to the primary
> service set-top box/home gateway that can be located anywhere in the house.
> The Gateway device will terminate the video and data for use at the primary
> TV, it will then forward the second video and data over the same cable pair
> to other set-top boxes and PCs within the house using HomePNA.
>
> Peer-to Peer (or server to server) communications requires that the service
> be adaptable so that full rate is available upstream or downstream as
> required by the user generated traffic. For example, it is now possible to
> record MPEG-1 video on a camcorder and e-mail it over the Internet.
> Unfortunately, sending the e-mail over a conventional fixed data rate
> ADSL/VDSL system takes forever for the 20 Mbps file.
>
> There is little demand for sending three simultaneous MPEG-2 video streams
> to the home. This is based on the analysis of over 20 million DBS and
> digital cable subscribers. In fact, two streams are required in only 30
> percent of households. It is far more economical to install a second
> Ethernet Subscriber Loop (ESL) for the one in 100 who want three HDTV videos
> than to burden all with the high costs required to support a higher bit rate
> short reach technology such as VDSL.
>
> In conclusion, long reach is of paramount importance. For delivery of two
> Standard TV signals, 10 Mbps at 12 km is required. For one HDTV plus one
> Standard TV, 20 Mbps at 12 km is desired. Also, the selected technology
> should allow data to flow in either direction at the full data rate.
> Finally, the technology should be spectrally compatible with HomePNA without
> requiring the use of a splitter at the residence.
>
> Finally, feedback on these ideas from other service providers and vendors is
> invited.