Re: [STDS-802-3-EPOC] minutes posted from today's Work Item and Socialization conference call
Avi,
I'm pretty much in agreement with your revised presentation on Resource Blocks. I have some issues with slide 2 but I think we can easily work these out.
I would prefer that some of these rules be expressed as applying to either Exclusions or Bursts rather than against RB's.
Rule about RBs:
* Type of 0 (no pilots), 1 (2 pilots) or 2 (2 pilots + 2 LD pilots) fixed in freq. during configuration
* All SC's have same configured length of 8, 12 or 16 sym. for entire transmitted spectrum (i.e., all channels)
* Any change in configuration (type or length) requires a restart
Rules about Exclusions:
* Min of 8 contiguous SC's between excluded SCs (i.e., exclusion bands separated by usable SC must have at least 8 non-excluded SC between them)
Rules about bursts:
* A Burst must start and end on a contiguous block (i.e., includes no excluded SC) of 8 SCs
Note that this establishes the minimum burst length and guard band between bursts
Burst(min) = Burst(guard) = Equivalent time of the 8 contiguous SC with lowest total bit loading
I think the above covers everything on Slide 2 plus a little extra.
Best Regards,
Duane
FutureWei Technologies Inc.
duane.remein@xxxxxxxxxx
Director, Access R&D
919 418 4741
Raleigh, NC
From: Avi Kliger [mailto:akliger@xxxxxxxxxxxx]
Sent: Saturday, June 14, 2014 11:21 AM
To: STDS-802-3-EPOC@xxxxxxxxxxxxxxxxx
Subject: Re: [STDS-802-3-EPOC] minutes posted from today's Work Item and Socialization conference call
Mark, all
Thanks for the good comments, attached a revised version trying responding some of the comments.
There are two pending issues that require more details and perhaps more discussions, once this is acceptable;
1. MDIO register structure - I believe this should be provided in a separate contribution once we all agree with the requirements
2. Do we want to bound the configurability of the pilot patters or leave it for the CLT RX implementation
Avi
From: Mark Laubach [mailto:laubach@xxxxxxxxxxxx]
Sent: Wednesday, June 04, 2014 8:53 PM
To: STDS-802-3-EPOC@xxxxxxxxxxxxxxxxx<mailto:STDS-802-3-EPOC@xxxxxxxxxxxxxxxxx>
Subject: [STDS-802-3-EPOC] minutes posted from today's Work Item and Socialization conference call
Dear IEEE P802.3bn Task Force Participants,
The minutes are posted from today's Work Item and Socialization conference call are available:
http://www.ieee802.org/3/bn/public/wias/
If you did not attend this meeting, please make sure to read the minutes and the presentations. As the Chair, I would like to try to motivate better focus and more technical details on the items that are still missing from our Task Force draft.
Yours truly,
Mark Laubach, Chair
IEEE P802.3bn EPoC PHY Task Force
Broadband Communications Group
Broadcom Corporation
1351 Redwood Way
Petaluma, CA, 94954
[broadcom.jpg]
Tel: +1.707.792.9093
Cell: +1.650.996.2219
________________________________
<="" p="">
________________________________
<="" p="">
________________________________________________________________________
To unsubscribe from the STDS-802-3-EPOC list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-3-EPOC&A=1
