Please
find update in the compliance tests part.
---
When an
Alternative A Midspan is connected to a 100BASE-TX PHY, the Midspan transfer
function gain shall be higher then 
from 100KHz to 1MHz at the pins of the PI used as 100BASE-TX
transmit pins with the additional requirement that the requirements will be met
with a DC bias current between 0 mA and TBD mA.
Compliance
test shall be performed by applying test signal to the Midspan signal input
through 100W±1%
source impedance. The Midspan signal output will be connected to 0.5m ±10% CAT5
cable, terminated with 100W±1%.
The transfer
function will be measured from the output termination to the test signal
source.
Chief R&D Engineer
Analog Mixed Signal Group
Microsemi Corporation
Neve Ne'eman Industrial Zone
Hod
Tel: +972-9-775-5100,
Cell: +972-54-4893019
Fax: +972-9-775-5111
E-mail: <mailto:ydarshan@microsemi.com>.
