[802.3af] RE: Single port insertion time issue.
Yair,
I agree with your conclusion. Definition A - The time to
see 44-57 volts on the output of the PSE is the right time to
measure. You could also say 33-57 volts at the PD input port
but I think specifying at the PSE will be easier to test. By
specifying any other time we are getting too far into the PD
and its operation, which I think we need not do. The
time "from PSE voltage at the port to Data being sent" is best
left to implementation.
Brian
>-----Original Message-----
>From: Yair Darshan [mailto:YairD@xxxxxxxxxxxxxx]
>Sent: Tuesday, June 12, 2001 2:21 AM
>To: 'stds-802-3-pwrviamdi-detection@xxxxxxxxxxxxxxxxxx'
>Cc: 'stds-802-3-pwrviamdi@xxxxxxxx'
>Subject: Single port insertion time issue.
>
>
>Guys,
>Attached short summary of the issue with the data that we have so far.
>Please review it in order to close this issue.
>
>Thanks
>
>Yair.
>
> <<Single Port Insertion Time -Considering System Aspects.pdf>>
>
>
>
>
>
>
>
>Darshan Yair
>Chief Engineer
>> PowerDsine Ltd. - Powering Converged Networks
>> 1 Hanagar St., P.O. Box 7220
>> Neve Ne'eman Industrial Zone
>> Hod Hasharon 45421, Israel
>Tel: +972-9-775-5100, Cell: +972-54-893019
>Fax: +972-9-775-5111
>> E-mail: <mailto:yaird@xxxxxxxxxxxxxx>.
>> http://www.powerdsine.com
>>
>> Visit PowerDsine at Networld+Interop 2001 Las Vegas
>> May 8-10, 2001, Booth: 8711,
>> Las Vegas Convention Center, Las Vegas, NV, USA
>>
>>
>>
>