OK, well, my question is: what is either primitive (the 11be one
or the proposed 11bn one) used for by the SME? In 11be/D7.0 the
use of the primitive is not described.
In 11me/D7.0 we have a Notify Channel Width frame from 11n,
an Operating Mode Notification frame from 11ac and
an OM Control field from 11ax. Yet we don't have any corresponding
MLME SAP primitives. Why does 11bn need one? (I'll raise a comment
in 11mf on the need for one for 11be.)
Thanks,
Mark
--
Mark RISON, Standards Architect, WLAN English/Esperanto/Français
Samsung Cambridge Solution Centre Tel: +44 1223 434600
1 Cambridge Square, Cambridge CB4 0AE Fax: +44 1223 434601
ROYAUME UNI WWW:
http://www.samsung.com/uk
From: Li Yan <li.yan16@xxxxxxxxxx>
Sent: Thursday, 19 December 2024 15:56
To: STDS-802-11-TGBN@xxxxxxxxxxxxxxxxx
Subject: [STDS-802-11-TGBN] Initiate the discussion of PDT-Joint-MLME-SAP
Hi all,
We can discuss more details for the relevant changes for MLME-SAP.
Firstly i would like to quote the EML operating mode notification in Table 6-1 MLME SAP interface in 11be_D7.0. However, my pure intention is that EML operaing mode notification
has been defined, then we propose a similar UHR operating mode notification. Therefore, i add such interface for UHR operating mode notification.
Best Regards！
Yan Li
To unsubscribe from the STDS-802-11-TGBN list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBN&A=1
To unsubscribe from the STDS-802-11-TGBN list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBN&A=1