Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: [STDS-802-16] [MMR-AH-UM] suggested addition for Section 3.2 In-Building Coverage Usage Model



DJ and all,

 

I think that the essential point that you bring up is that an RS in this usage model can have an antenna mounted externally for communication with the upstream RS or MMR-BS and an antenna mounted internally for communication with downstream RSs and/or MSs. I think that the detail about the two physical parts and the manner in which they connect describes one way of building such a device and should not be part of the usage model document.

 

I’ve added an item to the agenda to discuss this topic.

 

Regards,

Jerry Sydir

 


From: Shyy, DJ [mailto:djshyy@MITRE.ORG]
Sent: Wednesday, June 21, 2006 7:19 AM
To: STDS-802-16@LISTSERV.IEEE.ORG
Subject: [STDS-802-16] [MMR-AH-UM] suggested addition for Section 3.2 In-Building Coverage Usage Model

 

Hi All: Yair and I would suggest to add the following paragraphs at the end of the Section 3.2 In-Building Coverage Usage Model.

 

"

In some cases, it may not be possible or practical to place RSs near windows facing the donor BS. Another approach would be to deploy a split RS model.  In the split RS model, the RS would be split into two physical parts, one residing outdoors and the other indoors.  The outdoor unit (also called upstream unit) and the indoor unit (also called downstream unit) connected through some physical cabling such as an Ethernet link over CAT-5. The outdoor unit communicating with the BS is located on a roof or other outdoor location while the indoor unit servicing the building is located indoors.

 

In a large building, it may be required to have a single outdoor unit but multiple indoor units (e.g. one on each floor). In this case, the “split RS” model will need to be extended to address the configuration of a single upstream unit connected to multiple downstream units.

"

 

DJ Shyy