Re: [STDS-802-16] maximum traffic burst
Dear Juliana
Maximum Traffic Burst - describes the maximum continuous burst the system should accommodate for the service, assuming the service is not currently using any of its available resources. This parameter is needed because the physical speed of ingress/egress ports, any air interface, and the backhaul will in general be greater than the maximum sustained traffic rate parameter for a service.
The maximum traffic burst is defined by the application needs and the HW/SW capabilities of the BS/MSS. It is derived by the connection queue length, memory size and delay specified to this service flow.
I hope I answered your question
Best regards,
Avner Aloush
Chief Architect
DesignArt Networks
Tel: +972-9-7421306 Ext: 111
Fax: +972-9-7421296
Mobile :+972-54-4225583
www.designartnetworks.com
-----Original Message-----
From: Juliana Freitag Borin [mailto:juliana@IC.UNICAMP.BR]
Sent: Tuesday, August 19, 2008 8:44 PM
To: STDS-802-16@LISTSERV.IEEE.ORG
Subject: [STDS-802-16] maximum traffic burst
Hello,
is there any rule to configure the maximum traffic burst parameter?
What should be considered when configuring this parameter?
Thank you,
Juliana.