RE: [RPRWG] Question on ClassB client traffic
John,
If we do not have any buffering in the MAC, we'd bring down
the peformance of the client interface. For example, scheduler
could decide to accept an insert packet if there is no class A
transit packet at that moment. The client could take few clock
cycles to respond to the send signal. Meanwhile, we could have
a class A transit packet available. This will require us to
buffer the client packet in the MAC or throttle the class A
transit traffic until client responds and completes the packet
transfer. How do we address this scenario?
prasad
> -----Original Message-----
> From: John Lemon [mailto:JLemon@xxxxxxxxxxxx]
> Sent: Monday, July 01, 2002 2:52 PM
> To: 'Prasad Modali'
> Cc: Anil Nangunoori; stds-802-17@xxxxxxxx
> Subject: RE: [RPRWG] Question on ClassB client traffic
>
>
> Prasad,
>
> There is no buffer-full type of back pressure because the add queues (or
> buffers) are maintained by the client, not the MAC. Depending upon the
> implementation, the client may push a packet out of an add queue when the
> associated Send signal is active, or the MAC may pull a packet
> out of an add
> queue when the associated Send signal is active. In the former case, the
> client would need to use the Send signals to figure out when to send and
> what to send. In the latter case, the client could ignore the signals and
> just keep stuffing its queues. It's an implementation decision.
>
> jl
>
> -----Original Message-----
> From: Prasad Modali [mailto:prasad_modali@xxxxxxxxxxxxxxx]
> Sent: Thursday, June 27, 2002 6:11 PM
> To: Stds-802-17
> Cc: Anil Nangunoori
> Subject: [RPRWG] Question on ClassB client traffic
>
>
>
> Hi All,
>
> Annex I in D0.3 describes the MAC client behavior. The
> packet forwarding logic in the MAC has to give priority to
> the ClassA transit traffic. So a client inserting ClassB
> packets into the MAC could be back pressured by a burst
> of ClassA transit traffic.
>
> How does the client distinguish between buffer-full type
> of back pressure vs. ClassB rate shaping(tokens expiry)
> related back pressure? When classB tokens expire, client
> can still send classB packets if SendC is asserted.
>
> thanks
>
> --
> Prasad Modali
> Chip Engines Inc
> (408)991-9800 x116
>