Clarification on added B2/B3 bytes in WIS
Hi,
I would like to confirm my understanding of the B2 parity bytes
added in the WIS overhead as per the motions in Tampa last week.
Looking at SONET descriptions, each of the 192 B2 bytes represents
the BIP parity of each of the 192 ST1s in the last frame, but
Section Overhead is excluded, and parity is calculated before
scrambling. As such the B2 parity bytes meet the following rules:
1. exclude columns 1,2,3 and include columns 4-90 in rows 1,2,3
(i.e. excludessection overhead)
2. include columns 1-90 in rows 4-9, and as such,
includes the B2 byte from the last frame, in row 5, col 1.
3. includes the path overhead (first B2) and fixed stuff
(next 63 B2s) in the calculation for the SPE.
Correct?
Since the B2 bytes represent the BIP parity for the last frame,
there is 2x storage required for the history mechanism. Why does
martin_1_1100.pdf
show four 192x8 RAMS for hardware requirments to generate
the B2 bytes rather than two 192x8 RAMS (current frame and
last frame)?
Finally, for the B3 parity byte, ANSI T1.105-1995 states that
the B3 calculation excludes the fixed stuff bytes. For the WIS,
there are 63 bytes of fixed stuff after each path overhead byte
which are zero. Obviously these can't affect the parity
calculation on Tx (since they are zero), but the ANSI doc implies
that they should be ignored in the receiver (i.e. a bit error in
the fixed stuff will not cause a B3 parity failure). Is this
correct?
Thank you very much,
Gordon Jacobs