RE: [802.3ae] Link Fault Signalling
Burt,
Your understanding or the mechanism appears to be incorrect. Local Fault is
always sent on the path where the fault was detected. Therefore, if a fault
is detected on the transmit path, Local fault is sent on the transmit path
(toward the RS on the other side of the link.
Receiving local fault at an RS means "The path into this RS (the receive
path for this RS) has a fault." Receiving Remote Fault means that the path
to the partner RS has a fault.
Your item 2 is correct.
The RS never sends Local Fault.
Pat
-----Original Message-----
From: Burt Christian [mailto:burt@xxxxxxxxx]
Sent: Tuesday, December 04, 2001 7:07 PM
To: HSSG (E-mail)
Subject: [802.3ae] Link Fault Signalling
Hi,
I wanted to ensure that my understanding of the RS Link Fault
Signalling mechanism is correct. I am trying to understand the
mechanism rather than the details of the protocol. If someone
can please confirm the following description to be correct, I
would appreciate it.
1. If a fault on either the transmit path or the receive path
of PMD or PMA is detected then regardless of the quality of
the signal received by the PCS on the receive path, Local
Fault Ordered Sets will be transmitted by the PCS to the RS.
2. Once the RS Link Fault Signalling State Machine (Figure 46-9)
has entered the FAULT state with link_fault == Local Fault, RS
will start transmiting Remote Fault Ordered Sets on the transmit
path.
One thing I would like to confirm is that the Local Fault Ordered
Set will never be transmitted by the RS on the link where the link
is defined as the communication channel between two RS peers. This
is quite clear based on the very last section of 46.3.4.3 but I
would like to ensure that I am not missing anything.
Thank you.
Burt S, Christian.
Ceyba Inc.,
Systems Specialist
Tel : (613)599-5797
Fax : (613)599-1247
burt@xxxxxxxxx www.ceyba.com