Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

[802.3_ISAAC] Comments to remove from EZ



Please pull the following comments:

#28 was intended to be Proposed Reject (Tx/Rx PCS are simultaneous as XGMII is full-duplex)

#112 proposed resolution mentions transmitting the Z symbols on the MDI, but there was further discussion on best wording for 202.4.3.1 for Z symbols mapping from PMA service interface to MDI. 

  • Likely resolution is to refer to 202.5.2.4 contingent on EZ resolution of comment #260 which also defines Tx MDI behavior when tx_symb=Z, or use similar wording in both places.

 

The following could just be updated as below and remain EZ, or could be pulled if appropriate:

#39 proposed response says accommodated by #238, but should be accommodated by #184 and #185

#154 proposed remedy to replace “normal mode” with “data mode” can also be applied to Clause 202 (with editorial license)

 

Thanks

Scott

 

---

Scott Muma

Senior Technical Staff Architect

Microchip Technology, Inc.

Email: scott.muma@xxxxxxxxxxxxx

 

 


To unsubscribe from the STDS-802-3-ISAAC list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-3-ISAAC&A=1