Thread Links | Date Links | ||||
---|---|---|---|---|---|
Thread Prev | Thread Next | Thread Index | Date Prev | Date Next | Date Index |
Would one of you please
explain why IP issues have anything to do with a PAR? Isn't the purpose of
a PAR to authorize the investigation of solutions? Do we have to know what
the solution is before a PAR is authorized? If we don't know what the
solution is, can we know if there are any IP issues.
I'm confused.
David Wooten From: owner-stds-msc@LISTSERV.IEEE.ORG on behalf of Thomas Dineen Sent: Sat 3/12/2005 8:57 AM To: Michael Johas Teener Cc: IEEE 802.3 Residential Ethernet; IEEE MSC; Thomas Dineen Subject: Re: [RE] [REInterestGroup] 802.3 Residental Ethernet PAR: any MSC concerns? Michael:
Where there is smoke there is fire!!!!! Your very behavior on this issue has caused me to take it up as a concern! Your discussion shown below, while interesting, is irrelevant in that it details a list of layer 3 and above IETF public domain protocols, some of which by your own admission have patent issues. My concern is entirely focused on the requirement for a public domain layer 2 solution available under reasonable and non-discriminatory terms. This will allow for low cost and low complexity layer 2 only solutions. This concept will allow for layer 3 agnostic implementations, or for that matter implementations without layer 3 and its significant overhead. After all did that cheap ResE Speaker or cheap ResE Stereo really need an IP Address???? Do these low cost implementations really need to support the entire TCP / IP Protocol stack? I plan to oppose all ResE PARs until this issue is resolved. Thomas Dineen Michael Johas Teener wrote: Thomas, As one of the "loud" ones, I wish you would stop persisting in your claim that the discovery mechanisms that already exist are "proprietary" and "almost certainly not available to all implementers under RAND (reasonable and non-discriminatory) terms". I have noted a number of times in your presence, with your acknowledgement, there are a number of IETF discovery systems in place (free, and following IETF rules) including SLP (rfc2608 and its derivatives), DDDS (rfc3958) and multicast-DNS/DNS-SD (www.dns-sd.org, based on rfc2782). There are *many* others (too many, really). The industry is moving towards a UPnP-based system which, while based on various RFCs, is somewhat unique, and is a bit encumbered with IP issues. This issues, however, have NOTHING to do with RAND (all parties are committed to RAND ... and indeed to *free* licensing). There are NO, repeat NO "proprietary" protocols involved in all this. If you know of one, please be specific. I'm involved with at least three industry efforts, and I find myself at a loss to understand your insistence that there is a problem. Finally, why do we need a layer 2 service discovery protocol to be "competitive"? With whom? The only kind of discovery a layer 2 protocol needs is one that is required by the protocol itself ... such as a common synchronization source or "grand master" as it's called in IEEE 1588. Beyond that, we are getting into some rather major layering issues ... On 3/11/05 9:31 PM, "Thomas Dineen" <tdineen@IX.NETCOM.COM> wrote:David And All: Actually your posting dose bring to mind a concern about the Re Par Many if not most of the members of the RE Study Group, or at least a few loud ones, are against the development of a layer 2 Service Discovery protocol for Re. Favoring instead to use previously developed proprietary protocols. My concern lies in the concept that such proprietary protocols will almost certainly not be available to all implementors under reasonable non discriminatory terms. Leaving the future Re Industry in something of a patent licensing quagmire. Many have suggested the existence of layer 3 standard protocols is sufficient, but I disagree. I believe that we need a clean Layer 2 only architecture to be competitive. So I advocate the inclusion of an objective probably in the 802.1 Re Par to specify a Layer 2 Service Discovery Protocol. Further more I would suggest that both the 802.3 and 802.1 PARs be held, without consideration, until the issue is resolved. Thomas Dineen |