Thread Links | Date Links | ||||
---|---|---|---|---|---|
Thread Prev | Thread Next | Thread Index | Date Prev | Date Next | Date Index |
Hi all, I think there may be an error for the resolution of CID #2222 in revmd D4.0. The approved changes in 1443r2 is the following. At 158.5, change the definition of association in clause 3.1 from “The service used to establish access point/station (AP/STA) mapping ...” to “The service
used to establish a mapping between an access point (AP) or personal basic service set (PBSS) control point (PCP), and a station (STA) ...”. However, in revmd D4.0, we only have the following.
association:
(#2222)The service used to establish an access point (AP) or personal basic service set (PBSS) We can see that “a mapping between” is missing. I think this is probably an error and I am checking with the editor in revmd to figure this out. I assume that we can make change later when we figure this out.
Best, Po-Kai From: Dick Roy <dickroy@xxxxxxxxxxxx> From: Rojan Chitrakar [mailto:rojan.chitrakar@xxxxxxxxxxxxxxxx]
Hi Po-kai, As we discussed in yesterday’s call, it will be good to have a definition for MLD association similar to what we have for association: association:
(#2222)The service used to establish an access point (AP) or personal basic service set (PBSS) control point (PCP), and a station (STA) and enable STA invocation of the distribution system services (DSSs). [RR] This definition as written is seriously dysfunctional on several counts. It needs attention! Please do NOT use this as a template for MLD association. MTC, RR Regards, Rojan From: Huang, Po-kai <po-kai.huang@xxxxxxxxx>
Hi Yonggang, Thanks for the review. I provide my response in the attachment. Best, Po-Kai From: Yonggang Fang <yfang@xxxxxxxxx>
Hi Po-Kai, Thanks for the preparation. Attached is my comments and questions. Best Regards Yonggang Fang ZTE (TX)
Original Mail Sender: Huang,Po-kai <po-kai.huang@xxxxxxxxx> Date: 2020/08/26 15:49 Subject: [STDS-802-11-TGBE] PDT-MAC-MLO: General and Multi-link setup: Procedure Dear all, The proposed spec texts for agreements in MLO-General and MLO-Multi-link setup: Procedure is uploaded. Please take a look and let me know if you have further comments. Best, Po-Kai To unsubscribe from the STDS-802-11-TGBE list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBE&A=1 To unsubscribe from the STDS-802-11-TGBE list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBE&A=1 To unsubscribe from the STDS-802-11-TGBE list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBE&A=1 To unsubscribe from the STDS-802-11-TGBE list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBE&A=1 To unsubscribe from the STDS-802-11-TGBE list, click the following link:
https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBE&A=1 To unsubscribe from the STDS-802-11-TGBE list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBE&A=1 |