Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: [STDS-802-11-TGBE] PDT for Soft AP MLD



Kaiying,

 

I still believe that the concept that the Soft AP MLD (might) use the same antenna connectors as a set of non-AP STAs is not relevant to the standard, since this is talking about different instantiations of the device into active MLD(s).  Virtually every AP MLD ever created will have the possibility of using the antenna connectors as a non-AP MLD in some mode, at some time, through special firmware loads/diagnostics/etc.  That is not a distinguishing/distinguishable attribute.

 

I believe the concept we are after here is that only some special-case MLDs are ‘allowed’ to be non-STR, for example if they are battery powered, or mobile(?).  Perhaps we should just focus on that, with something like:


Soft AP MLD: An AP MLD with restricted capabilities, for example due to being battery powered.

 

Further, the MIB attribute looks more like a capability than an activation.  I think it should be a “dot1…Implemented” attribute.

 

Then, in the body text (because it is unusual and odd to list the MIB attributes in the definition), say “An AP MLD that has limited capabilities shall set dot11SoftAPMLDImplemented to true.”  We could expand upon the example cases where this attribute is appropriate/useful, as well, if there are other example beyond just “battery-powered”.

 

Thanks.  Mark

 

From: Kaiying Lu <Kaiying.Lu@xxxxxxxxxxxx>
Sent: Sunday, September 27, 2020 9:17 PM
To: STDS-802-11-TGBE@xxxxxxxxxxxxxxxxx
Subject: [STDS-802-11-TGBE] PDT for Soft AP MLD

 

Sorry for the confusion on subject of the email.

 

From: Kaiying Lu
Sent: Sunday, September 27, 2020 8:15 PM
To: 'Das, Subir'; STDS-802-11-TGBE@xxxxxxxxxxxxxxxxx
Subject: RE: PDT for NS/EP Priority Access

 

Hi all,

 

I have uploaded rev10.

This version addresses the following comments:

1. Soft AP MLD is one type of AP MLD that is in a batter powered device;

2. Soft AP MLD uses the same antenna connectors (RF chains) as a set of Non-AP STAs with/without non-AP MLD functionality.

 

https://mentor.ieee.org/802.11/dcn/20/11-20-1407-10-00be-pdt-mac-mlo-soft-ap-mld-operation.docx

 

Regards,

Kaiying

*********** MEDIATEK Confidentiality Notice ***********
The information contained in this e-mail message (including any 
attachments) may be confidential, proprietary, privileged, or 
otherwise exempt from disclosure under applicable laws. It is 
intended to be conveyed only to the designated recipient(s). Any 
use, dissemination, distribution, printing, retaining or copying 
of this e-mail (including its attachments) by unintended recipient(s) 
is strictly prohibited and may be unlawful. If you are not an 
intended recipient of this e-mail, or believe that you have received 
this e-mail in error, please notify the sender immediately 
(by replying to this e-mail), delete any and all copies of this 
e-mail (including any attachments) from your system, and do not 
disclose the content of this e-mail to any other person. Thank you!

To unsubscribe from the STDS-802-11-TGBE list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBE&A=1


To unsubscribe from the STDS-802-11-TGBE list, click the following link: https://listserv.ieee.org/cgi-bin/wa?SUBED1=STDS-802-11-TGBE&A=1