Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: [STDS-802-16] Fwd: [STDS-802-16] [PREAMBLE] reasonings for OMI

Title: Samsung Enterprise Portal mySingle
Dear Jiho,
 
I regret to say that your contribution fails to relate to the main reason why PUSC mode was invented, and this is the fact that FUSC and O-FUSC have coverage statistics which can go below 50% of the cell for many scenarios. With PUSC such issues can be dynamically controlled and optimized per the specific situation. PUSC supports reuse of 1/3 1/2 and 1/1, so there is no difference in efficiency if you choose to tune your network to sector reuse=1.
As for the others issues mentioned, I fail to see the advantages of O-FUSC as compared to FUSC (apart from making the life of the RF designer harder in order to meet spectral masks).
 
BR,
Yigal
-----Original Message-----
From: owner-stds-802-16@listserv.ieee.org [mailto:owner-stds-802-16@listserv.ieee.org]On Behalf Of Yossi Segal
Sent: Tuesday, August 10, 2004 11:13 AM
To: STDS-802-16@listserv.ieee.org
Subject: Re: [STDS-802-16] Fwd: [STDS-802-16] [PREAMBLE] reasonings for OMI

Hi Jiho,
 
I have some comments on your assumptions per your points:
1) As you stated FUSC uses all bandwidth but so can the PUSC, so you may trade BW/footprint and Interference as you like.
2) I am not sure the O-FUSC meets all the spectral masks (I am not sure such an analyses has been done, or at lease
I didn't see any), and it is gets very hard implementing these much carriers (more processing in some digital mechanisms
due to so much used BW). But if I am wrong then you are right.
3) The assumption of the hit probability must be between subchannels but if you use all the spectrum, you are hitting all
subcarriers all the time anyway (and I am not sure that the hit probability will be such a factor in this case - where different permutations
will be used for the PUSC zones, excluding the first 2 symbols).
4) Diversity gain difference is very small as the PUSC already has clusters scattered all over the spectrum, the difference will be between 24
clusters each with 2 subcarriers and 48 individual subcarriers.
 
And in any case you can switch zones just after the first 2 PUSC symbols, which are heavily coded, has better S/N and better
foot print when used in the 1/3 configuration.
 
Regards,
Yossi
-----Original Message-----
From: owner-stds-802-16@listserv.ieee.org [mailto:owner-stds-802-16@listserv.ieee.org]On Behalf Of Jiho Jang
Sent: Tuesday, August 10, 2004 3:33 AM
To: STDS-802-16@listserv.ieee.org
Subject: [STDS-802-16] Fwd: [STDS-802-16] [PREAMBLE] reasonings for OMI

Hi all,

 

I'm Jiho Jang from Samsung Electronics.

 

I have uploaded a material which describes the reasoning for the proposal of OMI (operating mode identification) for your information on http://temp.wirelessman.org.

Please find the uploaded file and look it over. Thanks.

 

Regards,

 

Jiho Jang





sec_logo.gif Jiho Jang (Ph. D)

NTP Development Team (System Lab. 2)

Telecommunication System Division

Telecommunication Network

SAMSUNG ELECTRONICS CO.,LTD

T. 82-31-279-3355

M. 016-9233-8541

jiho.jang@samsung.com