Hi All,
I suggest adding two parameters to the PHY Profile ID field:
1.
Cyclic prefix
for different cell sizes switch - 4 options: 1/4,1/8,1/16, 1/32 - 2bits.
2.
Reuse
Configuration - 2 options Asynchronous, Synchronous – 1 bit.
Would like to have your opinion on this
Thanks
- Yigal
-----Original Message-----
From: owner-stds-802-16@LISTSERV.IEEE.ORG
[mailto:owner-stds-802-16@LISTSERV.IEEE.ORG] On
Behalf Of Iyer, Prakash
Sent: Wednesday,
August 11, 2004 7:09 PM
To: STDS-802-16@LISTSERV.IEEE.ORG
Subject: [STDS-802-16]
[STDS-802-16-MOBILE] [HARMONIZATION] Logistics reminder and agenda for 8/11
telecon
For Wednesday,
8/11 telecon - Starts at 8 PM US Pacific time, bridge reserved for 3 hours
Dial-in number: 916-356-2663
Bridge: 1
Passcode: 2148540
Agenda:
* Idle mode and paging harmonization
* Periodic ranging and sleep mode
* Enhancement of association using SCAN
REQ-RSP
* PHY Profile ID
* Changes to NBR-ADV
* Update on SHO/FBSS harmonization
* Update and plan for MBS harmonization
* Update on IP address management (ARID
vs. Subnet zone ID etc.)
* Opens - another telecon this week to
closeout pending issues?