Dear Héctor,
I think this value has to be adapted according to the
deployment. You have to understand
this 'default' as a typical value. If you have to many
'ranging correction retries' your
system may be overloaded by single users "ranging
all the time".
If this value is to low you may do not support users at
the cell boarders, hard to range.
What I want to say is that this value will not be
fixed and nobody can tell you.
Each operator will use that "screw"
to optimize the overall BS
operation/traffic
throughput (my opinion).
Kind Regards
Juergen OTTERBACH
-----Ursprüngliche
Nachricht----- Von: Héctor Rubén Alba Díaz
[mailto:hralba@CETECOM.ES] Gesendet am: Mittwoch, 21. September 2005
13:30 An: STDS-802-16@LISTSERV.IEEE.ORG Betreff: Re:
[STDS-802-16] Ranging correction retries
Dear
All,
I would appreciate
some feedback on this question.
Thanks and best
regards,
Héctor
Dear
all,
In page 178 of
P802.16-2004/Cor1/D3, it is stated that the default value for the Ranging
Correction Retries is 16. However, no minimum nor maximum value is
specified. I would appreciate if somebody could clarify whether this
means that whichever value for this parameter is correct or, otherwise, to
give me some advise on it.
Thank you very
much in advance.
Best
regards,
Hector Alba Test Engineer
Telecommunications Division CETECOM - Spain Phone: +34
952.619.315 - Email: hralba@cetecom.es - Fax: +34
952.619.113
INFORMACIÓN
IMPORTANTE La información contenida en este e-mail va dirigida
únicamente a su destinatario y podría contener información confidencial, si
Ud. no es el destinatario indicado, no debe copiar, distribuir, o llevar a
cabo ninguna acción con el mismo. Si hubiera recibido este e-mail, por
error, por favor notifíquenos inmediatamente por e-mail o teléfono.
IMPORTANT NOTICE The information contained in
this e-mail is intended for the named recipients only. It may contain
privileged and confidential information and if you are not the intended
recipient you must not copy, distribute or take any action in reliance upon
it. If you have received this e-mail in error, please notify us immediately
by e-mail or
telephone.
|